공급 업체와 통신? 공급 업체
jiames.wang Mr. jiames.wang
나는 당신을 위해 무엇을 할 수 있습니까?
지금 채팅 공급 업체에 문의하십시오
JINING QINFENG MACHINERY HARDWARE CO.,LTD
> 산업 정보 > Introduction of taper of BT40 and BT50 high speed tool holder
온라인 서비스
jiames.wang

Mr. jiames.wang

메시지 남기기
지금 연락

Introduction of taper of BT40 and BT50 high speed tool holder

2019-08-07
In general, the most commonly used tool holder is BT tool holder. When the taper of BT tool holder is 7:24 And the speed is about 10,000 r/min, the tool holder-spindle system does not appear obvious deformation. But when the spindle rises from 10,000 r/min to 40,000 r/min, due to centrifugal force, the end of the spindle system will appear larger deformation, and its diameter jump from 0.2 M. It increased to about 2.8 M. Clearance between tool holder and taper hole of spindle will appear obviously, which seriously affects cutting characteristics of tool, so BT tool holder can not be used in high speed cutting generally.

There are several national standards for tool holders of machining centers. BT is Japanese standard (MAS403), taper is 7:24, size specifications are 60, 50, 40, 30.
"40, 50" represents the diameter of taper cross section of the tool handle.
BT40: The tolerance of 63mm diameter is - 0.05 to 0; the diameter of trapezoidal groove bottom is 53mm; the width of trapezoidal groove top is 10 mm tolerance is 0 to + 0.1; the angle of trapezoidal groove is - 15'to 0; the distance between the center of trapezoidal groove and the end of spindle (the big end of tool handle cone) is 16.6 mm tolerance is positive and negative 0.1.

BT50: The tolerance of 100mm diameter is - 0.05 to 0; the diameter of trapezoidal groove bottom is 85mm; the width of trapezoidal groove top is 0 to + 0.1; the angle of trapezoidal groove is - 15'to 0; the distance between the center of trapezoidal groove and the end of spindle (the big end point of tool handle cone) is 23.2mm and the tolerance is positive and negative 0.1.

tool holder

홈페이지

Phone

Skype

문의